Recently I’ve gotten back into making fabric boxes. They are so fun, quick, inexpensive and easy to individualize!
I made this one for me!
The inside grommet tape will hold straight pins and needles (sharp and blunt-tipped) and safety pins that I can use to keep things (little bits of ribbon, bias tape, baggies of supplies) in place while toting them around in this box.
Want to make your own exploding box or etui? Read on! No sewing is needed. Perfect gifts for those who don’t sew to make friends who do. Want to sew? Go for it! Glueing is much easier, though, and very sturdy!
You will need:
Chipboard, photo matting, cardboard or the like (maybe balsa wood?)
Thin quilt batting (I used cotton)
Glue (white tacky glue is fine)
Cord (silky cord works nicely)
Grommet tape, fabric, ribbon, ? for inside
Stuff to decorate outside (grommet tape, embroidery floss, beads, etc.)
Determine what shape, dimensions, features, whatever you want for your box. Cut the chipboard (or substitute) however you need. My new box is 4” x 6”. I cut four 4x6 pieces and two 4x4. Then I cut four 3.75x5.75” pieces and two 3.75x3.75 for the inside.
(not all pieces pictured)
Glue one side of all your pieces to the quilt batting. Cut batting to same size as board.
Cut your fabric so each piece is about a quarter to a half an inch bigger on each side of its board. Don’t glue the fabric onto the batting!
Lay chipboard batting side down on the wrong side of the fabric. Glue the corners of the fabric on the back (chipboard side) first then do the same with the edges.
Make sure everything dries securely.
Clothespins work well. So does sticking things under a book or laptop to dry
To make a hinge cut a strip or cloth as long as the edges you’re joining and about 1.5”-2” wide. Glue in half so right sides are showing both ways. Make enough for all the pieces you are hinging together.
To keep things nice and tidy trim hinges like so:
Push outside pieces close together (making sure it’s the layout you want) and glue the hinges on the back. Weigh down and let dry.
Take this opportunity to get interior decorating!
For the pin and needle holders I cut grommet tape to a little longer than the length of the chipboard…
…centered it onto the piece then glued it down on the back.
Glue down inside pieces. I started with ones that wouldn’t have silky cord string attached (the lid underside and the bottom.)
Cut and attach cord. Mine are round 22-23 inches long. Glue to back of front piece then glue back piece on top and help it dry securely.
Cut small pieces of cord for the loops. Glue them down so about a quarter of an inch sticks up past the edge. Thread long strings through and adjust loop size as needed. It should be a snug fit. Glue back piece on top.
Let dry. The waiting is the hardest part
Enjoy your work!