A Crafts Community For Craft Ideas & DIY Projects - Craftster.org
Help | About | Press | Advertise | Cookie Policy | Terms | Site Map
Welcome, Guest
News from Internet Brands:
Closing the Craftster Community on December 19, 2019.
Read the details here.
Total Members: 323,619
Currently Running With Scissors:
233 Guests and 0 Users
Home Craftster Community Crafting Articles Craft Tutorials Crafting Calendar City Guides
Pages: [1]
 1 
on: February 01, 2009 02:16:04 PM 
Started by violet_thistle, Message by Marinka
Relevance: 5.3%
I made one Smiley



You can't see the real colour on the Pic, it's more like this:


And some details:




Thanks for the idea Cheesy
 
 2 
on: August 20, 2008 04:20:37 AM 
Started by violet_thistle, Message by violet_thistle
Relevance: 38.7%
I really needed something in the car to stash litter.  What do you think?

I started with my 9 inch pie plate as a template for the circle bottom, cut out a 8 inch tall band to go around. The interior fabric is some outside patio fabric I found in the remnant bin; the exterior 100% cotton. Tute now follows pics by request.






Find something round to trace - I used a 9 inch pie plate.  Cut out a circle from your hefty outdoor material and from your cotton material. Cut a really long piece as wide as you want it tall. I think mine was about 8 or 9 inches wide. For length, I used roughly 27 inches long, after the second one.  But the first time I just used a really long piece.  ((There is a formula, but it never works for me!))

Now, sew a "stay stitch" line a half inch from one of the long edges of the long pieces. You are not sewing anything together, just a line. Now cut little snips along that same edge about an inch apart, but don't go past your stay stitch line.  This helps that long material go round the circle.  You'll have to do this for both the cotton and outdoor long pieces. NOTE: I found I needed to use a longer stitch on the outdoor fabric.

Now sew the circle to your long piece.  Be sure right sides are together and you are sewing along the edge that you stay-stitched and snipped.  Leave the first inch or two of the beginning of the long piece unsewn. Use a 1/2 inch seam allowance. When you start, be sure to backstitch a time or two. Sew a little, then rearrange the long piece so that it curves around the circle piece. No, I didn't pin - it was easier without the pins but make sure that stay stitch line doesn't show, sew right on top of it.) Once you get around the circle, stop about 1/2 inch away from where you started and backstitch a time or two.  With any luck, you'll have a wad of extra fabric at the end. Pull the whole thing out of the machine and use fingers or pins to judge where that seam for the long rectangle should be.  Line up the long rectangle's sides so that they are even.  You'll want to stitch the seam nice and perpendicular to the sides now. Back in the machine!

Now that the side seam is done, trim off all the excess material and go back and finish that little bit of circle that isn't done.  These are the thrills of sewing with no measurements.  (If you DID have excellent measurements, you could sew the long rectangle into a tube first, then sew onto the circle in perfect precision.)
Do this same circus act with the outdoor material, but remember the longer stitch length might be needed.

Now, Cotton material bucket should be right side out, but lining material bucket needs to be right side in.  Stick the cotton bucket inside the lining bucket. The two right sides will be touching. Now sew around the top edge with a 1/2 inch SA, leaving a gap for turning.  Don't forget to back stitch at start and stop points. 

Birth the bag! This is always my favorite part.  Turn your bag right side out (and if you are like me, you've made your gap too small and it takes some minutes of labour to get it all situated). Stuff the lining back down into the bucket.  It should look nearly done!

Top stitch 1/4 inch around the bag, being sure to tuck the material at that gap down and make it look nice and smooth.

Figure out how long you want your strap, cut and sew a tube and turn it right side out. Tuck the ends of the tube back inside 1/2 an inch and sew with reinforcing x's onto the bag straddling the side seam.








 
 3 
on: February 04, 2009 08:27:03 AM 
Started by violet_thistle, Message by Moek
Relevance: 5.3%
i feel a bit silly cause i made one but i don't have a car... hehe.

i just made it to put stuff in (mainly garbage while i'm sewing, like scrap fabric, thread, paper...) so mine isn't heavy duty at all.



thanks for the tute, and one day... when i decide to take driving lessons again, i'm gonna make one for my car!
 
Pages: [1]


FacebookTwitterPinterest
only results with images
include swap threads
advanced search
Crafting Ideas
Crafting How-Tos
Crafting Ideas
Crafting Topics



Latest Blog Articles
Tute Tuesday: Christmas Crack
Meal Prep Monday: Black Eyed Pea and Squash Soup
Craftster Featured Projects - Dedicated to the People Who Made It



Craftster heartily thanks the following peeps...
Moderators

Follow Craftster...






Powered by MySQL Powered by PHP Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC
SimplePortal 2.3.5 © 2008-2012, SimplePortal
Valid XHTML 1.0! Valid CSS!

Help | About | Press | Advertise | Privacy Policy | Cookie Policy | Terms | Site Map | Do not sell my personal information

Copyright ©2003-2017, Craftster.org, © 2009-2018 MH Sub I, LLC dba Internet Brands