A Crafts Community For Craft Ideas & DIY Projects - Craftster.org
Help | About | Contact | Press | Advertise | Cookie Policy | Terms | Site Map
Welcome, Guest.
Please login or register.
Random Tip: Join us for fun, contests and discussions on Craftster's Facebook page!
Total Members: 315,037
Currently Running With Scissors:
266 Guests and 9 Users
Home Craftster Community Crafting Articles Craft Tutorials My Craftster Crafting Calendar City Guides Craft Shop
  Show Topics
Pages: [1]
1  JEWELRY AND TRINKETS / Trinkets and Jewelry: Completed Projects: Reconstructed / yen necklace on: August 07, 2005 07:06:44 PM
I went to Japan about a year ago, and yesterday when I was cleaning my room, I found a whole change purse full of yen coins! There were a ton of 1 yen ones, which are worth less than a penny. They're made of aluminum, which makes them basically weightless. Soo..I made them into a necklace.

And a closeup of the coins...

2  PURSES, BAGS, WALLETS / Purses, Bags, Wallets: Completed Projects: General / Tutorial: mini totes for spring... on: March 28, 2005 05:48:10 PM

I tried to be as clear as I could, but if you have any questions, just ask! Also, if you need a photo of any of these steps, Id be happy to take one. Smiley

For these tote bags, youll need:
.5 yard outer fabric
.5 yard lining fabric
1 yard medium heavy to strong interfacing, depending on your preferences
4 extra-large eyelets
Extra-large eyelet kit, if youve never used extra-large eyelets before
1.5 yards grosgrain ribbon
1 magnetic snap

1. Cut out your materials. For the pattern, use a 15"x12" rectangle with 3" squares cut out of two of the corners.  I cut 36"x4" straps.  You'll need 2 outside pieces, 2 inside pieces, and 2 strap pieces.

For the outer material, I usually like to use some sort of cotton calico, and interface it with very strong fusible interfacing. For the interior, I use satin or some other kind of polyester blend. These are just suggestions, though; you can use any fabric you want!

2. The main bag portion is assembled according to Jordy's tutorial here: https://www.craftster.org/forum/index.php?topic=32204.0 First, assemble the lining and the bag portion SEPARATELY. Sew the straps, too. Press all seams. This is what youll have:

3. Now its time to sew the ribbon. How much ribbon you use depends on how long you want the tails of the bow to be, but you need at least 1.5 yards. I use grosgrain in varying widths, but I definitely wouldnt go smaller than 7/8. Its too hard to sew on otherwise!

Pin the ribbon to the outer bag. Start by marking the middle point of the bag. I generally just eyeball how far up to put the ribbon, but you can measure it if you want. Then, start pinning, leaving a tail of ribbon in front. Pin all the way around. When you get back to where you started, pin the ribbon down about 1 inch away from the other ribbon tail and snip the tails so that theyre the same length. Heres what it will look like:

4. Sew all the way around, close to the top of the ribbon. Then, take all of the pins out and, if necessary, re-pin the ribbon. You will need to sew the bottom of the ribbon down, too, and this is sometimes hard if the head of your pins are getting in the way of the sewing needle.

It might be tempting to not re-pin the ribbon, but it turns out neater this way, I promise. If you dont re-pin it, the grosgrain tends to twist on a bias, especially with thinner ribbon.

Now, sew all the way around again, close to the bottom of the ribbon.

Tie the ribbon into a bow and trim the tails to your liking.

5. Attach the magnetic snap to the lining. I measure and mark the middle of the lining, about 1 inches down from the top. If you use a thin lining, you might want to interface a small square behind the snap to make it sturdier. Also, see the magnetic snap tutorial: https://www.craftster.org/forum/index.php?topic=33694.0

6. Now, sew the lining to the bag according to the Jordy tutorial, but keep the straps separate!!! Pull the bag out through the hole you left in the lining and topstitch the hole in the lining with matching thread.

7. Press the top seam open and put the lining into the bag. Stitch around the top of the bag (like in the Jordy tutorial) for a neater edge.

8. Take a deep breath, because now youre going to have to cut holes in your pretty new bag. This is nerve-wracking the first time you do it, but its pretty much impossible to screw up, so dont worry!

Measure 2.5 from the side seam and 1.5 from the top of the bag, and mark it with a pencil. Do this twice on each side.

Then, cut holes where youve marked the dots. I use tiny sewing scissors to do this, since they poke through the thick material very well. The holes should be big enough to fit the eyelets, but not TOO big. Its better to err on the small side if youre not sure; the holes can always be cut bigger.  Also, dont worry if the edges of the holes are kind of jaggedyoull never see this in the final product.

9. Eyelet time! If youve never installed extra-large eyelets before, youll need to buy the Extra Large Eyelet Kit. The kit contains tools that are essential to the process.

I use Dritz brand eyelets because they are so widely available. Hancock Fabrics, Jo-Ann Fabrics, Hobby Lobby, Wal-Mart, and everywhere else I look all seem to have them. They come in a light yellow package!

Install the eyelets according to the back of the package. Basically, what youre doing is making a big sandwich. Put the round, washer-like tool down first. Then, put the smooth half of the eyelet down on the toolit will seem to fit in. Then, push the fabric down on the protruding part of the eyelet, with the right side of the fabric down. Finally, place the teeth half of the eyelet teeth down on the lining, and position the tool on top of it. Hammer the top of the tool solidly, several times, and presto! You have installed the eyelet! Do this 3 more times for the other holes youve cut.  

10. Youre almost done! Thread the straps through the eyelet holes, and tie knots in the ends. Voila! You have a super-cute tote bag!

I've been lurking around Craftster forever, but just joined...heh! Anyway, I went on a mini tote-making frenzy. what do you guys think?  Undecided  








Pages: [1]

only results with images
include swap threads
advanced search

Latest Blog Articles
Tute Tuesday: Altered Journal Page
Magic and Luck
Meatless Monday: Vegetarian Pasta Sauce

Support Craftster
Become a
Friend of Craftster

Buy Craftster Swag
Buy Craft Supplies

Craftster heartily thanks the following peeps...

Follow Craftster...

Powered by MySQL Powered by PHP Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC
SimplePortal 2.3.5 © 2008-2012, SimplePortal
Valid XHTML 1.0! Valid CSS!

Copyright ©2003-2018, Craftster.org an Internet Brands company.