Made most of these for friends of mine just wanted to show you what this site can make you do! I feel like an obsessive compulsive with a roll of duct tape!
First my friend michelle has always loved She-Ra! It brought back memories lol!
Next my very own designed duct tape purse..I can't believe it worked out!
The inside....
My wallet I made with hella credit card slots (I need em!). Don't forget the clear ID holder that I have my Sally Beauty card in.
white with silver lining!
AND OMG MY FAVORITE ONE OF ALL MARILYN MANSON!!!!!!
I had more but didn't want to bog you all down with mega pics! Oops I think I did that anyways? Tell me what ya all think?!
OK I don't know where to start with tutes but here it goes!
First I made a template for my bills roughly three inches tall with about an inch and a half on each side of a bill make two of those!
Then you line the tops with about a 3/4 inch strip of contrasting color.
Then I made the card slots the width of the duct tape for card holders make sure when you fold the bill holder in half it is not over half the size of the wallet or no id holder for you!!!
I used clear duct brand contact paper folded over to make the id holder and one sheet of matching size duct sheet for the pocket line one side of each and leave room so your id wont be squished.
Line both sides to put them together we will get back to that later.
Make a sheet the width of the card holders if you are not making many and place that under the contrasting strip of color on the top of your bill holder. If not tape your card holders together from behind to make sure your cards don't slip way down in your wallet.
Add your card holders with a strip of 3/4 inch contrasting color.
Fold your bill holder in half then split the top of the contrasting color and pull up to place your card holder in the middle with a strip of duct tape on each side that will finish your id holder.
NO PICTURE OOPS- with 3/4 inch contrasing color seal bottom of your wallet don't forget to split it where the id holder is.
Then for the sides I used the 3/4 inch duct tape to start at the bottom and go up only one side of the side? does that make sense and go up another 1/4 inch to overlap then split it to the top of the wallet.
Finally take the split end and fold over each side of the wallet on the inside and presto you have a liljinkss style duct tape wallet!!!
If you have any questions let me know I will try and clarify any problems you might have.
As for the round sliver purse I just used a bowl and cut off the top and bottom pieces then took one piece I cut off and used that attached to a rectangle to make the lid. The sides are also rectangles and the bottom to match the length of the sides of the circle. Hope that helps....
