My husband needs a CPAP machine and the latex head piece irritates his skin. So I have been making him covers and I thought I'd share in case it helps anyone else.
Sewing machine & thread
Soft material (I used flannel or terry cloth)
Button the size of the plugs
Paper & pen/marker
All of these steps you'll do twice since there are two, I recommended doing both together
First I took off the head piece and traced it onto paper
Then I cut it in half, folded the fabric in half and pinned it to the fabric and cut about 1/2 inch around
Unpin, unfold and line up with head piece. On one side mark in the center of the fabric where the plugs that snap into the mask. Make a line.
Put your sewing machine on the buttonhole setting, use the button that is a similar size to the plugs for the buttonhole foot and sew over your mark.
Then fold the piece over and sew around the edges leaving the bottom open ( you can skip sewing around the top because you have a fold there.
Turn inside out and slide onto the headpiece with the buttonholes opening for the plugs
Your done, now it's time to snap the plugs into the mask and have a good sleep!