i went to this and was wondering if you could give out measurements as well? would be easier :p
Sure thing - although, they're pretty simple, and if you occasionally see "if your bag was, for example 10 inches by 12 inches" or something of that nature, then those are actually my measurements. But - for clarification, the measurements of the pieces on the tutorial are as follows:
A (lining panel) - 10 inches wide by 12 inches tall
B (lining side panel) - 12 inches tall by 2 inches wide
C (lining bottom panel) - 10 inches long (wide) by 2 inches deep
Lining pockets D, E, F were all different sizes, each approximately between 4-8 inches wide and about 4-6 inches tall. Each one had a 1/2 inch folded over hem on all sides before they were sewn to the panel sides.
Outside panel H (cut 2) was 10 inches wide (plus seam allowance, approximately .5 inch on either side) by about 4 inches tall
Outside panel G was 14 inches wide by 9 inches tall. Although - if you wanted more pleats at the band you should make it wider
and the strap was the distance from my hip to around my shoulder and back again minus the width of the top of the bag (10 inches) plus 2 inches so that I could have about an inch into the bag at either side. I think that measurement was 50 inches. So, 50-10+2=42 inches long and I did it about 4 inches wide, folded it over, and pressed it flat (with the seam in the middle of the bottom of the strap) to make a 2 inch wide by 42 inch long strap.
Phew! Hope that helps!