I wanted to share these bubble mailers that I made this afternoon. I am out of the standard store-bought kind, but have a few orders that need to be shipped out this afternoon. I didn't have a lot of time to run around buying shipping supplies, so I dug through a box of craft supplies that I recently ordered online, and viola! bubble wrap! So I set to work making some small bubble mailers out of paper and recycled bubble wrap!
The paper is Martha Stewart paper that was on sale at my local craft store. I think it is supposed to be wrapping paper, I'm not sure. It was in the Clearance section for $1 a roll, originally priced at $7 each. I thought that it was cute, and for a buck a roll I grabbed a few not knowing what I'd do with them. Each mailer is 5x7 inches.
Two mailers (each has the pile of flesh going a different way):
Flipped over so you can see the closure flap on the back:
A close up (kinda blurry, sorry) that shows the bubble wrap inside:
Hey, glad you like them. Here is a attack that I made for them in case you want to try your own. Sorry about the juvenile images- I made it in Illustrator because I am now out of bubble wrap and can't show you through photos. Let me know if this doesn't make sense.
For supplies you will need:
- Decorative paper that is medium to heavy weight (scrapbook paper, wrapping paper, etc)
- Bubble wrap (the standard kind, not the stuff with the giant bubbles)
- White glue, or a heavy-duty glue stick. (You can also use permanent scrapbook adhesive tape)
- Clear tape
-Scissors or paper cutter
-Spray adhesive (optional)Step One:
Take a piece of decorative paper and cut it to be 11 x 9 inches.
Then, fold it following the graph below. (This is for an evelope that is 5x7, for a bigger envelope just double the width and add an inch for the "flap" on the side, and allow .5 in on the bottom and 1.5 in on the top for flaps also)Step Two:
Cut off the pieces marked in the diagram
Your paper will look like this:
Leave on the table right side down for the following steps.Step Three:
Cut two pieces of bubble wrap that are approximately 4.5 x 6.5 inches (slightly larger is better than too small)
and glue, bubble side down (so the smooth part faces towards you), to the wrong side of the paper inside the two 5x7 inch pieces. (The part without the pile of flesh) Leave about .25 inches on each side.
I glued mine with spray adhesive, but white glue will work ok for this. Be patient and let the glue dry if you use white glue. AND spread white glue thinly so the paper doesn't get wrinkles and warp where the glue made it too soggy.Step Four:
Once the glue is dry, use clear tape (packaging tape or scotch tape work fine) to tape down the top edge of the bubble wrap as marked in the diagram. This keeps it from peeling up when you fill the envelope. Step Five:
Put glue on the bottom two flaps of the paper and fold the envelope together. Press the bottom flaps together firmly and allow to dry. These will be secure if you used good glue, but if you are worried you can tape this seam. Your envelope will be connected on the bottom, but open with a 1 inch flap on the right side, and a 1.5 inch flap on the top like this:Step Six:
Put glue on the side flap, and fold over, securing it to the back of the envelope. For additional security, tape the flap as well. (This one likes to peel up otherwise!)
Now your envelope is done! Fill it and either glue or tape the top flap shut. If you have a solid color, dark colors, or busy pile of flesh, you will want to affix white mailing labels on the front to write you addresses on it. If you make some of these, I'd eat to see pictures!