Hi there folks,
Has anyone ever used too hot an iron and melted a patch of their fabric on a newly constructed garment?
If you have, can it be fixed? I tried wetting it and stretching it immediately afterwards but it didn't really do much.
My daughter just finished making a blouse/top out of polyester stretch satin and I was helping her out by ironing the seams flat so she could wear it to a special event at school tomorrow! What a good mom I am-NOT!
I do have enough fabric to rip out the front sleve and put a new one in but not before tomorrow at 8am!
I am praying she doesn't notice before she goes to school! It is right at the elbow bend so I hope she creases it with bending her arm before she notices it!
I will own up to it afterwards! lol